0
  • No products in the cart.

Purchase / Quote SAM Products

Sewage Pump Controller

Call for price

Know when your sewage pump is going to fail beforehand to save money and prevent a nightmare.

  • Turns on sewage pumps on or off from float inputs
  • Automatically detects and reports impending failure
  • Prevents overrun, over temperature, under and over power failures
  • Monitors pump and switch performance and reliability
  • Displays current status and main performance details with one button operation
  • Maintains total usage/pumped water/cycles/energy consumption
  • TOD (Time-of-Day) rate CA energy conservation compatible – call for details

Package includes:

1x Pump Controller

1x Quick Start Guide

 

 

This product is manufactured to order, lead time is two Weeks


Dimensions

Dimensions

Main block dimensions:  10 1/2″ Length x 7 3/8″ Width x 3 1/2″ Depth
Enclosure:  IP67 Aluminum NEMA Die Cast Box
Display dimensions:  6.30″ Length x 3.15″ Width x 2.17″ Depth
Enclosure: IP65 Polycarbonate, ABS NEMA 4
Floor Mounting bracket: StainlessSteel 15” Height x 6 ⅝ “ Width x 2” Depth
Wall Mounting bracket: StainlessSteel 5.5” Height x 9 ½ “ Width x ⅝” Depth
Design for indoor and outdoor (wet and semi-wet) locations.
Installation Steps

Installation Steps

Water Well Pump installation and configuration guide:

  1. Plan a space for the installation
  2. Install the bracket firmly to the floor or the wall
  3. Install Controller on top of the bracket and secure the two side screws
  4. Disconnect power from your source, and make sure you are safe
  5. Remove the existing pressure switch wiring and body and replace with a properly installed Pressure Sensor using the appropriate fittings
  6. Connect the Pressure sensor cable connector to the receptacle on the Controller
  7. Connect the pump wires to wires marked “TO PUMP” – with the same colors
  8. Connect the ground wire (green wire) from power source and the pump ground wire, and connect with the Controller ground wire (Green wire)
  9. Connect the incoming power wire labeled “TO POWER,” to the Disconnect switch
  10. Connect any auxiliary equipment at this time
  11. Check all connections, according to the installation plan
  12. Connect power
  13. Follow the directions on the Controller screen